Toshiba Magnia 510D - Manual (Page 70)

62
HW Diagnostics
IDE HDD TEST
[01. Sequential read test]
This subtest is a sequential reading of all the blocks on the HDDs, starting at block 0.
IDE HDD TEST (HDD) Error log
Status Error name Meaning
01 BAD COMMAND Bad command error
02 BAD ADDRESS MARK ERROR Bad address error
04 RECORD NOT FOUND The sector has not been found
05 HDC NOT RESET ERROR HDC reset has been failed
07 DRIVE NOT INITIALIZE Bad drive parameter error
09 DMA BOUNDARY ERROR DMA BOUNDARY occurred
0A BAD SECTOR Bad sector error
0B BAD TRACK Bad track error
10 ECC ERROR Read error (illegal ECC)
11 ECC RECOVER ENABLE ECC error recover enable error
20 HDC ERROR Hard disk controller error
40 SEEK ERROR Hard disk seek error
80 TIME OUT ERROR Time out error
AA DRIVE NOT READY Drive not ready error
BB UNDEFINED ERROR Undefined errors
CC WRITE FAULT Write fault error
E0 STATUS ERROR Status error
F0 NOT SENSE ERROR Other errors (HW. CODE = FF)
FE NOT DRIVE ERROR Drive has not been found
FF DATA COMPARE ERROR Data comparing error
NOTE: The [01. Sequential read test] tests all areas of the hard disk drive.
If the capacities of installed hard disk drives are large enough, the test may take a few hours.