After installation (windows 2000) – Toshiba Magnia 510D User Manual
Page 45
39
Setup
After Installation (Windows 2000)
After Installation
(Windows 2000)
If you have finished Windows 2000 Server installation, then follow the steps below:
Confirming and Setting up the Time Zone
1.
Start Windows 2000 Server and log on to it as the Administrator (or a user having
equivalent rights).
2.
Run Date/Time Properties by clicking Start, Settings, Control panel, and
double clicking on Date/Time.
3.
Click Time Zone tab.
4.
Check that the current Time Zone setting is correct. If incorrect, select the correct
setting and press [OK].
Setting up the AMI RAID utility (MR466 RAID Controller only)
If the MR466 RAID Controller exists on your server and you want to use the AMI
RAID utility (Power Console, Service, SNMP Agent), you must install it manually after
the Windows 2000 Server installation.
To install the AMI RAID utility, follow your MegaRAID User's Manual.
Installing the VIA 4in1 driver
The necessary modules for the VIA 4in1 driver installation are included on the SST
CD-ROM, as shown below. Install the VIA 4in1 driver by executing SETUP.EXE.
For more information, refer to your MAGNIA510D User's Guide.
Selecting the display driver
After the VIA 4in1 driver installation, follow the steps below:
1.
Start Windows 2000 Server, and log on to Windows 2000 Server as the
Administrator (or a user having equivalent rights).
2.
Run Display Properties from Windows 2000 Server, by clicking Start, Settings,
Control Panel, and double-clicking Display.
3.
Select the Settings tab, then click Advanced.
4.
Select the Adapter tab, then click Properties.
5.
Select the Driver tab, then click Update Driver.
6.
When the Update Device Driver Wizard starts, click Next.
7.
Select Display a list of the known device… , then click Next.
8.
Insert the SST CD-ROM, then select Have disk. Enter the following path, then
select OK:
9.
Select "NVIDIA Vanta", then click Next.
(After this, follow the instructions that appear on screen.)
Setting up the Active Directory (To make this server as a domain controller)
If you installed TCP/IP protocol and you want to designate this server as a domain
controller in your network, you must install Active Directory.
For more information about Active Directory, refer to the Windows 2000 Server Help.