Pioneer SPH-DA100 - Manual (Page 45)

08 Customising preferences
Chapter
45
Engb
Customising preferences
Restoring the default settings
Resets various settings registered to this prod-
uct and restores them to the default settings.
❐ “ System Reset ” can be set only when the
source is set to “ OFF ”.
1 Display the “System” screen.
➲ For details, refer to Customising the system
settings on page 38.
2 Tap [System Reset].
A message confirming whether to restore the
settings appears.
3 Tap [OK].
■ If you do not want to restore the settings,
tap [
Cancel ].
Checking the connections of leads
Check that leads are properly connected be-
tween this product and the vehicle. Please also
check whether they are connected in the cor-
rect positions.
1 Display the “System” screen.
➲ For details, refer to Customising the system
settings on page 38.
2 Tap [Connection Status].
The “ Connection Status ” screen appears.
GPS Antenna
Indicates the connection status of the GPS
aerial, the reception sensitivity, and from
how many satellites the signal is received.
Colour Signal
communication Used in
positioning
Orange Yes Yes
Yellow Yes No
❐
When the GPS aerial is connected to this
product, “
OK ” is displayed.
When the GPS aerial is not connected to
this product, “
Not OK ” is displayed.
❐
If reception is poor, please change the in-
stallation position of the GPS aerial.
Positioning Status
Indicates the current GPS positioning sta-
tus.
2D Positioning:
The status when the signals from three
satellites are received.
3D Positioning:
The status when the signals from four or
more satellites are received.
Back Signal
When the gearstick is shifted to “ R ”, the
signal switches to “ High ” or “ Low ”. (One of
these is displayed depending on the vehi-
cle.)
•
•