Pioneer SC-LX82 - Manual (Page 13)

Controls and displays 02
13
En
13 Remote control illumination button
Press to turn on/off the illumination of some of the
buttons and the LCD light. 1
14 Remote control operation selector switch
Set to
RECEIVER to operate the receiver, TV or SOURCE
to operate the TV or the source device.
When this switch is set to RECEIVER, the receiver can be
controlled (used to select the white commands above the
number buttons (
A.ATT, etc.)). Also use this switch to set
up surround sound.
15 VOL +/–
Use to set the listening volume.
16 MUTE
Mutes the sound or restores the sound if it has been
muted (adjusting the volume also restores the sound).
17 AUDIO – Changes the audio or channel on DVD or
BD discs.
DISP – Switches between named station presets and
radio frequencies.
CH +/– – Use to select channels for DVD/DVR units.
Note
1 Press and hold in the remote control illumination button for 5 seconds to change the illumination mode 1 or 2. When set to LIGHT M2 (default),
the illumination only lights when the remote control illumination button is pressed. When switched to LIGHT M1, the illumination lights
whenever buttons are operated. Setting LIGHT M1 will shorten the service life of the batteries.
SC-LX82_LX72.book Page 13 Thursday, April 23, 2009 7:05 PM