Pioneer AVIC-HD3 RU - Manual (Page 176)

174
Ap
pe
nd
ix
NAVI
/A
V
Messages for Audio Functions
When problems occur in the audio source, a message may appears on the display. Refer to the table
below to identify the problem, then take the suggested corrective action. If the error persists, contact
your dealer or your nearest PIONEER Service Centre.
Built-in DVD drive
Calibration failed.
Please refer to the owner’s manual.
The touch panel calibration has not
been carried out with appropriate
steps.
Please read the instruction of touch
panel calibration and retry.
➞ Page 160
The HDD is not connected. Failure of the built-in hard disk drive
has occured, such as internal electri-
cal problem or file system error.
Consult your dealer.
Cannot use HDD. Failure of the built-in hard disk drive
has occured, such as internal electri-
cal problem or file system error
Consult your dealer.
There is no applicable program. Failure of the built-in hard disk drive
has occured, such as internal electri-
cal problem or file system error.
Consult your dealer.
The HDD cannot be operated due to
excessive heat.
Please move your vehicle to a safe
place and turn the power off until the
temperature goes down.
Hard disk drive cannot run due to
high temperature.
Park your vehicle to safe place, turn
the ignition switch off and wait until
the temperature inside the vehicle
drops.
Message When What to do
Unreadable disc. If you try to use a disc which is incom-
patible with this system.
Insert a suitable disc.
If you insert a disc upside down. Insert the disc with the label upward.
If the disc is dirty. Clean the disc.
If the disc is cracked or otherwise dam-
aged.
Insert a normal, round disc.
Mechanical failure of DVD drive occur. Consult your Pioneer dealer.
Playback error.
Please remove the disc.
Electrical or mechanical error has
occured.
Press the RESET button. (“Hardware
manual” after reading page 157 in this
manual.)
Region code error The disc does not have the same region
number as the navigation system.
Replace the DVD-Video with one bearing
the correct region number.
Playback error due to irregu-
lar temperature. Please
remove the disc.
The temperature of built-in DVD drive
exceeds the operating limits.
Park your vehicle to safe place, turn the
ignition switch off and wait until the
built-in DVD drive’s temperature returns
to within normal operating limits.
ATTENTION!
Viewing of front seat video
source while driving is strictly
prohibited.
Handbrake interlock is activated. Park your vehicle in the safe place and
apply the handbrake.
➲ Handbrake interlock ➞ Page 18
Search error If the title number, chapter number,
time or 10 key command that you enter
in [10Key Search] do not exist. (This
message will appear when the DVD
drive cannot accept that command.)
Enter the available numbers or 10 key
command or use another search
method.
Message When What to do