Pioneer AVIC-HD3 RU User Manual
Page 170
168
Ap
pe
nd
ix
NAVI
/A
V
Slope is not displayed on the
Vehicle Dynamics screen.
Inclination does not move on [3D
Calibration Status] screen.
The speed pulse lead is not con-
nected.
Connect the speed pulse lead.
No sound, no voice.
“Guide Mute” has been set, or sound
volume is reduced to 0.
Adjust the volume of the guidance or
turn “Guide Mute” off.
Refer to “Setting the Volume for
Guidance and Phone” (➞ Page 79).
The estimated time of arrival is differ-
ent from the actual time of arrival.
This phenomenon is normal,
because the estimated time of arrival
is affected by various factors such as
traffic jams or shortcuts.
The estimated time of arrival is an
ideal value calculated based on the
value set for [Average Speed] and
the actual driving speed. The esti-
mated time of arrival is only a refer-
ence value, and does not guarantee
arrival at that time.
When importing an image, the file
name does not appear correctly.
The name of the imported image file
contains a diacritical mark (such as
ä or è) or Cyrillic.
Letters with diacritical marks or Cyril-
lic letters cannot be recognised, so
the file name may be garbled or not
appear. Rename the file with stan-
dard Latin characters (A-Z, a-z) and
numbers (0-9) and retry. If you want
to use Cyrillic letters or letters with
diacritical marks for file name, fina-
lise the CD-R(-RW) with Joliet (Uni-
code) format.
➲ “Limitations for importing pic-
The name of the imported image file
is not written in Unicode.
The file name may not appear cor-
rectly for file names written in con-
flicting character codes. Select Joliet
for the file name conversion in the
writing software and burn to the CD-
R.
The person on the other end of the
phone call cannot hear the conversa-
tion due to an echo.
The voice from the person on the
other end of the phone call is output
from the speakers and then picked
up by the microphone again, creat-
ing an echo.
Use the following methods to reduce
the echo.
— Lower the volume on the receiver
— Have both speakers pause
slightly before speaking
The registered phone cannot be
deleted.
Normally, the registered phone can-
not be deleted.
• Overwrite the old registered phone
with a new phone.
• Clear [Phone Settings] by refer-
ring to “Returning the Navigation
System to the Default or Factory
When the screen is frozen...
Park your vehicle at a safe place, and cut off the engine. Turn the ignition key back to “Acc off”. Then
start the engine again, and turn the power to the navigation system back on. If this does not solve the
problem, press the RESET button on the navigation system.
Symptom
Cause
Action (See)