Pioneer AVIC-HD3 RU User Manual
Page 174
172
Ap
pe
nd
ix
NAVI
/A
V
Route calculation not possible
because destination is too close.
The destination or waypoint(s) are
too close.
Set a destination and waypoint(s) far-
ther from the starting point.
Route calculation not possible due to
traffic regulations.
• The destination or waypoint(s) are
in a Control Traffic Zone (CTR) and
the route calculation is hampered.
• Your vehicle is currently in a Con-
trol Traffic Zone (CTR) and the
route calculation is hampered.
• Set a destination and waypoint(s)
outside the CTR if you know where
the restricted area is.
• Try the destination or waypoint(s)
away from the currently set points
to some extent.
• Drive your vehicle to an unre-
stricted area and reset the destina-
tion and waypoint(s).
Route calculation not possible
because navigation cannot be pro-
vided around destination or starting
point.
The destination, waypoint(s), or start-
ing point are in an area where no
road exists (e.g. a mountain) and the
route calculation is impossible.
• Set a destination and waypoint(s)
on roads.
• Reset the destination after you
drive the vehicle to any road.
Route to destination cannot be cal-
culated.
The destination or waypoint(s) are in
an isolated island, etc. without a ferry
and the route calculation is impossi-
ble. If there is no road connected to
your starting point or destination,
this message will appear.
Change the destination.
• Ferry could not be avoided.
• Toll roads could not be avoided.
• Motorway could not be avoided.
• Ferry, toll roads and motorways
could not be avoided.
• Ferry and toll roads could not be
avoided.
• Toll roads and motorways could not
be avoided.
• Ferry and motorway could not be
avoided.
These messages appear when a ferry
route, toll roads or motorways are
included in the route to the destina-
tion or waypoints even though a
route is set to avoid them.
You can identify these condition by
the icons.
If the current route is not desired, set
destination or waypoints that do not
pass through a ferry route, toll roads
or motorways.
This area does not contain any POI’s
of the selected type.
Facilities of the selected category do
not exist in the surrounding areas.
Use another search method or move
to another location and perform the
[Vicinity Search] again.
Failed to make the route profile.
In rarely case the route calculation
error may occur.
• Retry.
• Consult the Pioneer Local dealer if
this message persists.
There is no pictures folder. Please
create /Pictures/ folder and store
JPEG files in that Folder.
Cannot load the image because the
Pictures folder is not found in the
inserted disc.
Use the appropriate data after read-
ing “Limitations for import the pic-
ture” on page 85.
Data Read error.
Failed to read the data because the
CD-R is damaged or dirty. Or, the
pick-up lens of the DVD drive is dirty.
Try re-reading the data by inserting a
clean CD-R.
Clean the pick-up lens with a com-
mercially available cleaning kit for
DVD, then try to reading again.
The Pictures folder exists on the CD-
R but no data in JPEG format exists.
Use the appropriate data after read-
ing “Limitations for import the pic-
ture” on page 85.
JPEG file is corrupt.
The data is damaged or an attempt
was made to set a JPEG image, that
is out of specifications, as the back-
ground picture.
Use the appropriate data after read-
ing “Limitations for import the pic-
ture” on page 85.
Message
When
What to do