8 safety precautions 8.9 legal notices, 1 safety, Cautions and warnings 08 – Pioneer KRP-500M User Manual
Page 87

87
En
Cautions and Warnings
08
Englis
h
8.8
Safety Precautions
Your flat panel display is engineered and manufactured with one of the highest priorities being safety. However,
improper use can result in electric shock and/or fire. To avoid danger please follow the instructions below when
installing, operating, and cleaning your flat panel display.
• Read & Retain Instructions - Read all operating and user information provided with your flat panel display.
• Environment - Avoid installing the panel in a location with exposure to large quantities of dust, temperature
extremes, high humidity, direct sunlight, or subject to excessive vibrations or impact shock. Also, never pour
a liquid or insert an object in to the flat panel display.
• Cleaning - See the section above regarding the proper way to clean your flat panel display.
• Water & Moisture - Avoid operating or positioning your panel close to water or other sources of liquid. Such
locations include a bathroom, a kitchen or laundry sink, in a damp basement, by a swimming pool, etc.
• Power - Turn OFF the panel before connecting any other equipment. Operate the panel only from a grounded
outlet.
8.9
Legal Notices
8.9.1
Safety
WARNING:
This product equipped with a three-wire grounding (earthed) plug - a plug that has a
third (grounding) pin. This plug only fits a grounding-type power outlet. If you are unable to insert
the plug into an outlet, contact a licensed electrician to replace the outlet with a properly grounded
one. Do not defeat the safety purpose of the grounding plug.
D3-4-2-1-6_A_En
WARNING:
To prevent a fire hazard, do not place any naked flame sources (such as a lighted
candle) on the equipment.
D3-4-2-1-7a_A_En
VENTILATION CAUTION:
When installing this unit, make sure to leave space around the unit for ventilation to improve heat
radiation. For the minimum space required, see page 15.
WARNING:
Slots and openings in the cabinet are provided for ventilation to ensure reliable
operation of the product, and to protect it from overheating. To prevent fire hazard, the openings
should never be blocked or covered with items (such as newspapers, table-cloths, curtains) or by
operating the equipment on thick carpet or a bed.
Operating Environment
Operating environment temperature and humidity:
+0 ºC to +40 ºC (+32 ºF to +104 ºF); less than 85 %RH (cooling vents not blocked)
Do not install this unit in a poorly ventilated area, or in locations exposed to high humidity or direct sunlight
(or strong artificial light)
D3-4-2-1-7c_A_En
WARNING:
Do not use or store batteries in direct sunlight or other excessively hot place, such as
inside a car or near a heater. This can cause batteries to leak, overheat, explode or catch fire. It can
also reduce the life or performance of batteries.
D3-4-2-3-3_En
KRP-600M_500M.book Page 87 Tuesday, May 13, 2008 12:47 PM