Pioneer KRP-500M - Manual (Page 78)

78
En
06 Use Other Equipment With Your Flat Panel Display
• Banner Input: determines the input signal for the small window in P-in-P mode
Note: The higher the resolution becomes on the main screen image, the lower the contrast becomes on the small
window image.
Signals that support Banner PIP are XGA 60 Hz and WXGA 60 Hz.
IP Control Lock
This locks or unlocks the IP Control settings.
Note: This setting applies to all input sources.
Network ID Beacon
This option authenticates the connection between the specified equipment and the flat panel display.
Parameter Description
Translucent On adjusts the translucent rate
Off* No effect
Banner PIP Off* No effect
Bottom 1 through 3 adjusts display positions
Mid Low/High
Top 1 through 3
Banner Input INPUT 3* through 6 determines the input signal
*Factory default
Parameter Description
On locks the IP Control settings
Off* No effect
*Factory default
Parameter Description
On applies the Network ID Beacon
Off* No effect
*Factory default
MID HIGH
MID LOW
270 540 810 1080
1920
TOP 1
TOP 2
TOP 3
BOTTOM 1
BOTTOM 2
BOTTOM 3
The Banner sub-screen option uses only the
top 1/4 of a PC signal input. When adding a
picture or text, the image or text must be
placed in the top 1/4 area.
KRP-600M_500M.book Page 78 Tuesday, May 13, 2008 12:47 PM