Pioneer AVIC-X3 - Manual (Page 63)

61
Ch
ap
te
r
4
Ed
it
in
g t
h
e N
aviga
tio
n
Ut
il
it
ies
NA
V
I
(1) Distance
Driving distance is indicated.
(2) Speed Pulse
Total number of speed pulses is indicated.
(3) Learning Status
Current driving mode is indicated.
(4) Degree of learning
Sensor learning situations for distance
(Distance), right turn (Right Turn), left turn
(Left Turn) and 3D detection (3D Detection)
are indicated by the length of bars.
❒ When tyres have been changed or chains fit-
ted, turning on the Speed Pulse allows the
system to detect the fact that the tyre diame-
ter has changed, and automatically replaces
the value for calculating distance.
❒ If the ND-PG1 is connected, the distance cal-
culation value cannot be replaced automati-
cally.
(5) Speed
Speed detected by the navigation system is
indicated. (This indication may be different
from the actual speed of your vehicle, so
please do not use this instead of the speedom-
eter of your vehicle.)
(6) Acceleration or deceleration/Rota-
tional speed
Acceleration or deceleration velocity of your
vehicle is indicated. Also, rotational speed
when your vehicle turns to left or right is
shown.
(7) Inclination
Degree of slope of the street is indicated.
To clear values...
If you want to delete the learned results stored in
“Distance”, “Speed Pulse” or “Learning Sta-
tus”, touch the relevant result, then touch
“Clear”.
❒ The navigation system can automatically use
its sensor memory based on the outer dimen-
sions of the tyres.
Checking the connections of
leads and installation positions
Check that leads are properly connected between
the navigation system and the vehicle. Please
also check whether they are connected in the
correct positions.
1
Touch “Settings” in the NAVI MENU,
then touch “Hardware Info”.
2
Touch “Connection Status”.
The Connection Status screen appears.
(1) Speed Pulse
The Speed Pulse value detected by the naviga-
tion system is shown. “0” is shown while the
vehicle is stationary.
(2) GPS Aerial
Indicates the connection status of the GPS
aerial, the reception sensitivity and from how
many satellites the signal is received.
If the signal is received correctly, “OK” is dis-
played. If reception is poor, “NOK” appears.
(3) Installation Position
The installation position of the navigation sys-
tem is shown.
If installed correctly, “OK” appears. Indicates
whether the installation position of the naviga-
tion system is correct or not. When the navi-
gation system is installed at an extreme angle
exceeding the limitation of the installing
angle, “Incorrect angle” will be displayed.
When the angle of the navigation system has
been changed, “Excessive vibration” will be
displayed.
(4) Hand brake
When the handbrake is applied, “On” is dis-
played. When the handbrake is released, “Off”
is displayed.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
MAN-AVIC-X3-EN.book Page 61 Wednesday, June 6, 2007 10:15 AM