Olympus E-100 RS User Manual
Page 203
203
12
SYMPTOM
The monitor is not clear.
POSSIBLE CAUSES
1
The brightness is not
adjusted properly.
2
The monitor is exposed
to direct sunlight.
CORRECTIVE ACTION
1
Adjust the brightness.
2
Block the sunlight.
REF. PAGE
P. 163
SYMPTOM
Image rotate, Image protect, Single-erase, All-frame erase and Card
formatting cannot be performed.
POSSIBLE CAUSES
1
A write-protect adhesive
seal is affixed to the
card.
CORRECTIVE ACTION
1
Use the card after peeling off
the seal. Do not reuse the
write protect seal.
REF. PAGE
P. 43
SYMPTOM
When the camera is connected to a computer, an error message appears
while data is being transferred to the computer.
POSSIBLE CAUSES
1
The cable is not plugged
in correctly.
2
The power is OFF.
3
The batteries are
exhausted.
4
The USB driver is not
installed properly.
CORRECTIVE ACTION
1
Connect the cable correctly.
2
Turn on the camera, then set
the Mode dial to
.
3
Replace the batteries with
new ones or use the optional
AC adapter.
4
Check the USB driver’s
installation guide, and make
sure the camera is
recognized.
REF. PAGE
P. 182–187
P. 187
P. 33–38