Xerox 4112-4127 ST con Xerox EX Print Server powered by Fiery-15679 - Manual (Page 8)

Page 8
PCL print jobs cannot be set on the Fiery over IPP (Internet Printing Protocol)
PCL files that contain job programming are not supported by the Fiery from FreeFlow.
If job programming is required for your job, use the Fiery PCL printer driver.
FreeFlow Job Cancel
If you select Cancel from FreeFlow Status using the Fiery print path, the job does not cancel
on the Fiery, even though FreeFlow displays that the job cancelled successfully.
Output Tray names
FreeFlow output locations correspond to different output tray names in the Fiery user
interface. The following table lists these equivalents:
Jobs without finishing are delivered to the HCS Top Tray or HCS Stacker Tray, if attached.
Jobs with finishing are delivered to the Finisher Top Tray or Finisher Stacker Tray.
Jobs with Coil Punch are delivered to the HCS Top Tray or HCS Stacker Tray, if attached,
otherwise they are sent to the Finisher trays.
Z-Fold Half Sheet - Right Bind jobs that print inside
FreeFlow jobs with “Z-Fold Half Sheet - Right Bind print inside” and any combination that
includes 2 Staples, Center Staple, or Hole Punch - Right Portrait print with the image rotated
180 degrees on the page.
FreeFlow Print Manager Fiery
Printer’s Default
Automatic AutoSelect
Top Tray Offset Catch Tray (OCT), HCS Top Tray, or D4
Finisher Top Tray
Stacker D4 Finisher Stacker Tray or HCS Stacker
Stacker 2 D4 Finisher Stacker