Xerox DocuColor 242-252-260 con built-in Fiery controller-14683 - Manual (Page 3)

Page 3
Installation Obtaining the FreeFlow enablement file
The FreeFlow enablement file is available from WebTools or www.xerox.com.
The enablement file applies to the entire suite of FreeFlow applications, which includes
FreeFlow Express to Print, Makeready, Process Manager, Web Services, Print Manager,
and Output Manager, version 8.0.
Installing the Fiery FreeFlow enablement file
You can apply the enablement file directly through System Updates. To download the file to
the Fiery, use the following procedure.
T O INSTALL THE F REE F LOW ENABLEMENT FILE
1 To access Fiery WebTools, start your Internet or intranet browser and type the DNS name or
IP address of the Fiery.
2 Click the Configure tab.
3 Click Check for Product Updates.
4 Click Yes on the Security Information window.
5 Click the link for the FreeFlow patch.
6 Save the zipped file to the desktop.
7 Unzip the file to the desktop.
8 Import the patch file, 1-13LK3J.ps, with Command WorkStation to the Fiery Direct queue.
Wait approximately 60 seconds after the patch file is downloaded/imported before rebooting
the system. This ensures that the patch file is completely processed.
9 From Command WorkStation or the Fiery Control Panel, select Shut Down, and then select
Reboot System.
Allow the Fiery to restart without interruption.
10 When the Fiery reaches Idle, print a Configuration page and verify that the Update
Information section includes the file name: 1-13LK3J.