Admin settings] 3-68 – Konica Minolta bizhub C35 User Manual
Page 115
[Admin Settings]
3-68
[Fine Line ADJ]
Settings
-3 to 2 (Default: 0)
Adjust how fine lines are reproduced by chang-
ing the applied voltage (VC) to the electrostatic
roller.
[AIDC Mode]
Settings
[Mode 1] / [Mode 2]
Select the AIDC operation mode.
[Mode 1]: Standard mode
[Mode 2]: Low mode
[Thick Mode]
Settings
[Quality Mode] / [Speed Mode]
In order to prevent toner from clogging within
the developer unit as a result of it being driven
at half-speed, select the timing for driving the
developer unit at full speed for a fixed length of
time when thick paper is being fed.
[Quality Mode]: While printing on thick paper,
printing is periodically paused, and the devel-
oper unit is driven at full speed for a fixed
length of time. Since printing is paused, the
quality is not affected; however, a standby time
of approximately 70 seconds occurs every 400
seconds or so of half-speed operation.
[Speed Mode]: While printing on thick paper,
only the drive of the developer unit periodically
switches to full speed for a fixed length of time.
Since printing continues during full-speed
drive, the print quality is slightly affected, how-
ever the standby time is short.
[Engine DipSW]
Change the DIP switches to control machine
operation.
[Engine DipSW 1] -
[Engine DipSW 28]
Settings
[ON] / [OFF]
Use to change engine settings.
"
Normally, there is no need to change the
settings. If it becomes necessary to
change the settings, do so according to
the instructions from the service
representative.