beautypg.com

5 limiting machine usage: weekly timer, To use the machine temporarily, Limiting machine usage: weekly timer -29 – Konica Minolta bizhub PRESS 2250P User Manual

Page 37

background image

bizhub PRESS 2250P

2-29

2.7

Using Machine When Power Save LED Lights

2

2.7.5

Limiting Machine Usage: Weekly Timer

Weekly Timer turns a machine on and off at the time specified by the administrator.

When a machine is in OFF condition under control of Weekly Timer, the Power Save LED is lit and machine
operation is unavailable.

d

Reference

Weekly Timer settings are provided on the Utility Menu Screen.

To use the machine temporarily

The following procedure temporarily enables the machine operation. (Timer Interrupt)

1

Press Power Save on the control panel.

The Machine Screen will be displayed along with the message shown below.

[Timer interrupt mode / Please enter password]

% If the message [Please specify desired copy time / 0 hour(s) 05 minute(s)] is displayed, proceed to

step 3.

% The machine power will be turned off automatically after 5 minutes from this state without any op-

eration made.

2

Enter the Timer Interrupt password, then press Start on the control panel.

Enter a 4-digit Timer Interrupt password using the control panel keypad, then press Start.

[Timer interrupt mode / Please enter password ****]

% The Timer Interrupt password (Password Non-Business Hours) is specified in the Administrator Set-

ting on the Utility menu. Ask your administrator for the specified Timer Interrupt password.

% If an invalid password is entered, continue by entering the valid 4-digit password.

3

Set the hour for the interrupt use, then press Start on the control panel.

Enter a 1-digit hour (from 0 to 9) using the control panel keypad, then press Start.

[Please specify desired copy time / 3 hour(s) 05 minute(s)]

4

Set the minute for the interruption use, then press Start on the control panel.

Enter a 2-digit minute (from 0 to 59) using the control panel keypad, then press Start.

[Please specify desired copy time / 3 hour(s) 30 minute(s)]

Machine operation is now available with the message [Ready to print] displayed on the screen, until the
set time is up.

% To specify a 1-digit minute, enter [0] first to make it two digits. However, you cannot specify the time

shorter than 5 minutes. Entering 0 for hour and a number smaller than 5 for minute will set the minute
at 5. Also, a number larger than 60 is unavailable for minute.

5

When the machine operation is finished within the set period of time, hold down Power Save on the
control panel for over a second.

The machine returns to OFF condition.