Chapter 2 – Konica Minolta OpenText FaxPress User Manual
Page 13
5
Chapter 2
Configuring the Konica Minolta MFP Module to Use the FaxPress
This chapter describes how to register the FaxPress server with the
Konica Minolta MFP and how to create FaxPress applications on
the Konica Minolta MFP device. FaxPress applications are
FaxPress services with preconfigured parameters. This chapter
discusses using Konica/Minolta PageScope Web Connection to
register the FaxPress server and to create FaxPress applications.
Please refer to the Konica/Minolta PageScope Web Connection
documentation for information about accessing the PageScope
Web Connection utility and registering and configuring
applications.
This document approaches registering and configuring the
FaxPress server with the Konica Minolta MFP as though it is the
first such application that you are registering. However, for the sake
of clarity, we have opted to break the initial set up into two parts.
The first part describes how to register the hardware. The process
that you actually follow my differ depending on a number of factors
including but not exclusive to the Konica Minolta MFP module and
the current configuration. Refer to your Konica Minolta MFP
documentation for detailed instruction.
Registering the FaxPress Server with the
Konica Minolta MFP Device
The section describes how to register the FaxPress server with the
Konica Minolta device.
Note The graphical user-interface screens that appear in this document
may differ from those that appear on your Konica Minolta MFP device
depending on many factors including model and version of release. Refer
to your Konica Minolta MFP documentation for instructions about how to
configure the device to use an external application.
Requirements
Optional fax kit not installed
Internal faxing is disabled
To register your Konica Minolta MFP device to use the FaxPress
server for faxing, do the following:
1.
In a Web browser of a local PC workstation, enter the
IP address of the Konica Minolta MFP device. The PageScope
Web Connection appears. See Step Figure 2.1.