Konica Minolta Bizhub 215 - Manual (Page 16)

bizhub 215 2-8
2.3 Setup procedure 2
2.3 Setup procedure
To use this printing system, you must complete the setup in advance.
The setup refers to a series of procedures for connecting the machine to the computer and installing the print-
er driver to the computer.
Perform the setup using the following procedures.
2.3.1 For local connection (USB port)
1
Connect this machine to the computer.
2
Install the printer driver.
% If the standard printer controller is installed, install the GDI printer driver.
% If optional Image Controller IC-209 is installed, install the PCL printer driver.
% When you install the printer driver, WIA and TWAIN scan drivers are installed at the same time.
2.3.2 For network connection
1
Connect this machine to the computer.
2
Check that the computer to be used is connected to the network.
3
Specify the IP address of this machine, and then connect it to the network.
4
Change the network settings for this machine according to the connection method or protocol.
% LPR: From [TCP/IP Configuration]-[LPD Setting], enable LPD printing.
% Port 9100: In [IPv4 Configuration], enable the RAW port number (initial setting: [9100]).
% IPP: In [IPP Configuration], enable IPP printing.
% Web Service Print: In [WSD Configuration], enable [Use WSD Browsing].
% When you install the printer driver, WIA and TWAIN scan drivers are installed at the same time.
5
Install the printer driver.
% If Network Card NC-504 is installed on the standard printer controller, install the GDI printer driver.
% If optional Image Controller IC-209 is installed, install the PCL printer driver.
% Specify the network port for the printer driver according to the connection method or protocol.
Tips
- After installing the printer driver, perform test print to make sure that the connections are made prop-
erly.
d
Reference
For details on the network settings, refer to the [User's Guide Network Administrator].
The procedure for installing the printer driver varies depending on the connection method, operating system
of the computer, and printer driver. For details, refer to page 3-2.
To update an existing printer driver, uninstall it first. For details, refer to page 3-17.