Konica Minolta ScanDiva - Manual (Page 68)

ScanDIVA User’s Guide
3-38
4. Black and White: This option is only active when the Image Type is set to “1bit BK/W”.
Remove the check mark under Diffusion Dither to convert the image to
binary data.
5. Color Profile Setting: Sets the Color Profile.
Source (Scanner):
It should normally be set to the initial setting,
"PSHG_ICCDFLT_A2.icc".
Target:
It should normally be set to the initial setting,
"sRGB Color Space Profile.icm".
Rendering Intent:
It should normally be set to the initial setting, "Perceptual".
6. Stitch: 1. Smoothing Level:
The alignment of image stitching can be adjusted in five stages.
It should normally be set to the initial setting, "Center".
2. Threshold:
The threshold of image stitching detection can be adjusted in five
stages.
It should normally be set to the initial setting, "Center".
3. Warning Level:
If the result of the stitching gaps is unjustified, a warning message is
displayed
The warning level can be set in 5 stages.
It should normally be set to the initial setting, "Center".