beautypg.com

1 precautions for installation, 1 installation environment, 2 power source – Konica Minolta ScanDiva User Manual

Page 20: Precautions for installation -2, Installation environment -2, Power source -2

background image

ScanDIVA User’s Guide

1-2

1 Precautions for Installation

1.1 Installation Environment

Install the Scanner in a location, which meets the following requirements to ensure safe
operation and utmost performance.

 A well-ventilated place
 An area which is free from ammonia or other organic gases.
 A place which has easy access to a power outlet so that the unit may be easily plugged and

unplugged.

 An area free from direct sunlight
 A place which is not directly under room lighting.











 Place where uneven lighting on the Book Table is not caused by interior illumination and

outdoor light.

 Within the range of 200 to 500lx in luminance on the Book Table.
 A place which is out of the direct air stream of an air conditioner, heater or ventilator and is

not subject to extremely high or low temperatures or humidity.

 A stable location with a flat surface that is not subject to undue vibration.
 A place away from curtains or other objects that catch fire and burn easily
 An area that is safe from spilled water or other liquids.
 A dust-free location

1.2 Power Source

The Power Source Voltage Requirements are as follows.

 Use a Power Source with little voltage/frequency fluctuations.

Power Source:

50 Hz – 60 Hz

Voltage Fluctuation:

120 VAC ±10%, 230 VAC ±10%

Frequency Fluctuation:

50 Hz ±3 Hz

60 Hz ±3 Hz

 Be careful not to exceed the capacity of the outlet, especially when sharing other appliances

from the same outlet.

 The outlet should be located near the unit and be easily accessible so that the Power Cord

can be unplugged immediately if necessary.

 NEVER connect any other appliances or machines by means of a multiple socket to the

outlet being used for the unit.

 If an Extension Cord is needed, use one with a capacity greater than the power consumption

of the unit.

 Make sure that the Power Cord and extension cord do not become caught in any mechanism

of the system. Do not allow either the power or extension cord to become caught underneath
the weight of the unit.

Room lighting

Room lighting

Operator

Room lighting

Operator

Room lighting