Konica Minolta ScanDiva - Manual (Page 45)

Chapter 3 ScanDIVA TWAIN Driver
3-15
2.5 Exposure Time
This Adjustment is to match the Exposure Level to the luminance of the installation
location.
1 Place the “Setup Adjustment Sheet” on the Adjustment Plate.
NOTE ! Refer to “2.4 CCD Gain” above to place the “Setup Adjustment
Sheet”. If the glass plate is attached, close it.
2 Select “4 Exposure Time” on the pull-down list under “Detail & Adjustment”,
and then click “Run”.
3 Click “OK” on the confirmation screen to confirm the test chart.
4 The window indicating that adjustment is underway will appear. When the
window disappears, the adjustment is completed. Proceed to the next
adjustment, “2.6 Black Shading”.