7 replacing a fusing unit, Replacing a fusing unit -23 – Konica Minolta bizhub C3850 User Manual
Page 35
[Maintenance/Troubleshooting]
2-23
2.2
Replacing consumables
2
5
Install the filter case in the main unit.
6
Select [Utility] - [Administrator Settings] - [System Settings] - [Expert Adjustment] - [Life] - [New Release]
- [Toner Filter], then reset the counter.
2.2.7
Replacing a Fusing Unit
After the Fusing Unit replacement message has appeared, printing is possible, but the printing quality re-
duces. Immediately replace the Fusing Unit.
7CAUTION
-
The Fusing Unit is too hot. It may cause a burn injury; therefore, leave the Fusing Unit out for 20 minutes
or more until it reaches room temperature after turning the power off. Then, replace the Fusing Unit.
1
Turn off the power of this machine.
2
Pull the lever (1), then open the Right Door (2).
% When opening the Right Door, be sure to fold the Manual Feed Tray in advance.