beautypg.com

Konica Minolta bizhub 222 User Manual

Page 86

background image

Troubleshooting

6

362/282/222

6-5

The stapling position is
not as expected.

The orientation setting is not
correct.

Check the stapling position in
the printer driver setup dialog
box.

The hole punch function
cannot be specified.

Hole punching cannot be speci-
fied if “Booklet”, “Transparen-
cy”, “Thick2”, “Thick3”, or
“Envelope” is selected.

Check each setting in the printer
driver.

For the hole punch function, the
punch unit must be installed on
optional finisher.

Install the required optional fin-
isher and enable it using the
printer driver.

The pages are not
punched.

Printed pages may be fed out
without being punched if the pa-
per is loaded into the paper
source with an incorrect orienta-
tion.

Check the orientation setting.

The hole punch position is
not as expected.

The orientation setting is not
correct.

Check the punch position on the
Layout tab of the printer driver
setup dialog box.

The form is not printed
properly.

Available computer memory
space is not sufficient.

Simplify the form to reduce the
data size.

The image is not printed
properly.

Available computer memory
space is not sufficient.

Simplify the image to reduce the
data size.

Paper is not fed from the
specified paper source.

Paper will not be fed from the
specified paper source if that
paper source is loaded with pa-
per of a different size or orienta-
tion.

Load the paper source with pa-
per of the appropriate size and
orientation.

The numbering function is
not performed.

The “Collate” (for Windows) or
“Collated” (for Mac OS X) check
box is selected on the print set-
up dialog box.

Clear the “Collate” (for Win-
dows) or “Collated” (for Mac OS
X) check box.

Proof and Print is no be
performed.

Symptom

Probable cause

Action

This manual is related to the following products: