Konica Minolta BIZHUB C252 - Manual (Page 189)

3 Specifying Settings From the Control Panel
3-78 C252
Sp
ec
ifyin
g
Set
tin
gs
F
ro
m
th
e
Co
nt
ro
l Pa
ne
l
Chapter 3
3.18 Setting Up LDAP Settings
The LDAP server can be registered and authentication settings can be spec-
ified.
LDAP Server Registration Parameters
The LDAP server registration parameters are as follows:
Setting Up LDAP screen 1/6
Setting Up LDAP screen 2/6
* When [LDAP Function] is set to “ON” on the Enabling LDAP screen, the [Check Connection] key
is displayed only when [Manual Destination Input] is set to “Allow” on the Security Details
screen.
Item Description
LDAP Server Name Set the LDAP server name to be registered. Use the key-
board that appears in the touch panel to type in the server
name (up to 32 characters).
Max. Search Results Set the maximum number of destinations to display after
searching. To change the value, press the [C] (clear) key,
and then use the keypad to type in the value (between 5
and 1000 destinations).
Timeout Set the maximum wait time for the search operation. To
change the value, press the [C] (clear) key, and then use the
keypad to type in the value (between 5 and 300 seconds).
Initial Setting for Search Details Specify the initial setting of the search conditions when
performing a detailed search. For details on specifying the
setting, refer to “Initial Setting for Search Details” on
page 3-85.
Check Connection Checks the connection to the LDAP server.
Reset All Settings The LDAP server settings can be reset to the default set-
tings that were specified at the factory.
When a reset confirmation message appears, touch [Yes].
Item Description
Server Address Sets the IP address of the LDAP server. Use the keyboard
that appears in the touch panel to type in the address (up
to 255 characters).
Search Base Specify the search starting point in the hierarchical
structure that is arranged in the LDAP server. Searchers are
performed by also including the lower sub-directories from
the starting point that was specified. Use the keyboard that
appears in the touch panel to type in the address (up to 255
characters).
Check Connection* Checks the connection to the LDAP server.
Reset All Settings The LDAP server settings can be reset to their factory
default.
When a reset confirmation message appears, touch [Yes].