Konica Minolta magicolor 5570 - Manual (Page 144)

Finishing 130
Finishing
When the optional staple finisher is installed, job separation, offset and staple
printing can be performed. For the installation procedure, refer to “Staple Fin-
isher” on page 246. Settings can be specified for job separation, offset and
staple printing by selecting
JOB SEPARATION or FINISHING in PAPER
MENU .
"
Use the following paper with job separation, offset and staple printing.
"
Paper is fed to the main output tray with job separation, offset and sta-
ple printing.
Job Separation Printing
When paper is fed to the main output tray, the pages are fed out shifted as
shown below.
"
When paper is fed to the sub output tray, the pages are fed out
stacked on top of each other without begin shifted.
"
If staple printing is selected, the pages are stapled together before
being fed out.
Media Types Plain paper, Recycled paper and Letterhead
(changes according to the paper thickness)
Media Size Width: 182 to 216 mm
Length: 257 to 355.6 mm
2
1
4
3
2
1
3
2
1
3
2
1