Konica Minolta magicolor 5570 - Manual (Page 118)

Media Types 104
Use envelopes that are
„ Common office envelopes approved for laser printing with diagonal joints,
sharp folds and edges, and ordinary gummed flaps
"
Because the envelopes pass through heated rollers, the gummed
area on the flaps may seal. Using envelopes with emulsion-based
glue avoids this problem.
„ Approved for laser printing
„ Dry
DO NOT use envelopes that have
„ Sticky flaps
„ Tape seals, metal clasps, paper clips, fasteners, or peel-off strips for seal-
ing
„ Transparent windows
„ Too rough of a surface
„ Material that will melt, vaporize, offset, discolor, or emit dangerous fumes
„ Been presealed
Labels
A sheet of labels consists of a face sheet (the printing surface), adhesive, and
a carrier sheet:
„ The face sheet must follow the plain paper specification.
„ The face sheet surface must cover the entire carrier sheet, and no adhe-
sive should come through on the surface.
You can print continuously with label sheets. However, this could affect the
media feed, depending on the media quality and printing environment. If
problems occur, stop the continuous printing and print one sheet at a time.
Try printing your data on a sheet of plain paper first to check placement.
Check your application documentation for more information on printing labels.
Duplexing Not supported
Glossy
Mode Not supported
Capacity Tray 1
(Manual Feed
Tray) Up to 20 label sheets, depending on their
thickness
Tray 2/3/4 Not supported
Orientation Face down