Norgren U.L. Listed Beverage Regulators - Manual (Page 12)

Littleton, CO USA Phone 303-794-2611 Fax 303-795-9487
R82 Regulator
● Underwriters Laboratories, Inc. listed (file number
SA1089)
● The R82 regulator with integral relief valve meets the
requirements of Proposed Section 9.7, Draught Beer
Dispensing Equipment and Related Components
(Seventh Draft dated October 17, 1980), of ANSI-
ASME F2.1-1975, Food, Drug, and Beverage
Equipment.
● Integral relief valve easily replaced without
disassembly of regulator and without affecting relief
pressure setting
● Back flow check valve, or manifold with integral
check valve at each outlet, can be installed in
regulator outlet port. Manifolds available with 3 or 5
outlets and include one outlet cap.
● Relieving diaphragm allows outlet pressure setting to
be reduced even though the system is dead-ended.
Pressure downstream of check valves will not be
reduced.
● Easily replaceable valve cartridge contains valve,
valve seat, valve spring, and filter element
● Two high pressure ports (inlet and primary gauge)
and two regulated pressure ports (outlet and
secondary gauge)
● Diametrically opposite inlet ports facilitate
manifolding for multiple dispensing applications.
Each manifolded regulator operates independently as
though attached directly to the gas supply source.
● Bonnet wrench hex same size as tank adapter - one
wrench fits both
UL Listed, Cylinder Gas Pressure Regulator
1/4" PTF, CO
2
Regulator for Beer Dispensing Systems
Technical Data
Fluid: Carbon dioxide. The R82 regulator is designed for use in beer dispensing
systems to control cylinder gas (carbon dioxide) pressure to the beer keg.
Other Norgren regulators (R81 for soft drink syrup containers, R84 for soft drink
carbonators, R83 for industrial cylinder gases) are available for use in other
systems.
Maximum pressure: 3000 psig (207 bar)
Operating temperature: 0° to 140°F (-18° to 60°C)
Maximum outlet pressure adjustment limit: Factory set at 40 to 45 psig (2.8 to 3.1 bar)
Integral relief valve cracking pressure:
60 ± 4 psig (4.1 ± 0.28 bar)
Materials:
Body: Brass
Bonnet: Zinc
Valve cartridge: Teflon, brass, stainless steel
Diaphragm: Acetal and nitrile
Relief valve: Brass, polycarbonate, nitrile, aluminum
Seals: Nitrile
ALE-12-12
See Section ALE-25 for Accessories