EasyN H3 Series User manual - Manual (Page 8)

MH3E-E-A2 - 7 -
computer-1 can access camera-1，then configure router-1（do port forwarding in
router-1），to transfer the computer-2’s access apply to go through router-1 then to
camera-1. Normally, computer-2 only can reach router-1 without port forwarding for
camera-1.
4.3 Connect network via ADSL
™ Connect camera to router through cable.
™ Configure parameters via IP Camera tool (refer to:
5.1 IPcamera tool ).
™ Login device by administrator，access PPPOE settings page to input user and password..
™ After information input click “Set” by enabling DDNS service meanwhile to restart
device.(refer to: 5.6 DDNS configuration )
™ Connect to internet via ADSL then we can access camera by domain name link through
internet.
4.4 Access network through router
5.
Software operating
1) Connect device to LAN via cable
2) Configure device’s parameters.(refer to: 5.1
IPcamera tool )
3) Access device with administrator.
4) Access ddns settings page to enable DDNS
service then click “Set” to restart device. (Refer to:
5.6 DDNS configuration )
5) Access with ddns link through internet.