EasyN H3 Series User manual User Manual
Page 34

MH3E-E-A2
- 33 -
Step 4: click “Linkage Alarm” to select alarm type
Step 5: enable arm function for device, otherwise it can not support alarm linkage
v.
PTZ
For ptz control, it should be fulfill with right parameters, different ptz has
different protocol, protocol code and baud rate.
vi.
System
After select time, click “Set Time” to modify time of device
【
Sync with computer time
】
tick then click “Set Time” to enable
【
Reboot
】
click to reboot
【
Restore
】
click to restore factory settings, after restore, need to reboot to
reconfigure network parameters of device for reconnection