RADWAG Low profiled scales - Manual (Page 83)

- 83 -
22. TROUBLE SHOOTING
Problem Cause Solution
Discharged batteries.
Connect to mains or
change batteries
Turning on does not
work
No batteries (not installed or
improperly installed) Check the correctness of
installation (polarization)
The scale turns off
automatically „t1” set to „YES” (Power
save) In „othr” submenu change
„5.4 t1” to „no”
After turning on „LH”
message on the display Loaded weight pan during
powering up Unload the pan. Then the
scale will indicator zero.
23. ADDITIONAL EQUIPMENT
• KAFKA printer cable for PUE C/31 indicators - P0136,
• KAFKA printer cable for PUE C/31H, PUE C/31H/Z - P0253,
• Computer cable for PUE C/31 - P0108,
• Computer cable for PUE C/31H, PUE C/31H/Z - P0259,
• EPSON printer cable for PUE C/31 - P0151,
• EPSON printer cable for PUE C/31H, PUE C/31H/Z - P0261,
• Power cord for car lighter 12V DC for PUE C/31 - K0047,
• Power cord for car lighter 12V DC for PUE C/31H/Z - K0042,
• Thermal printer - KAFKA,
• Dot matrix printer - EPSON,
• Additional display in plastic casing for PUE C/31- WD- 4/1
(accessible with balance as complete set only),
• Additional display in stainless metal housing for PUE C/31H, PUE
C/31H/Z - WD- 4/3 (accessible with balance as complete set only),
• Large size display (2”) for PUE C/31H, PUE C/31H/Z - WWG-2,
• Current loop in plastic casing for PUE C/31 - AP2-1,
• Current loop in metal housing PUE C/31H, PUE C/31H/Z - AP2-3
(accessible with balance as complete set only),
• RS232 / RS485 converter for PUE C/31 – KR-01,
• RS232 / Ethernet converter for PUE C/31 - KR-04,