WIKA DI10 User Manual

Page 12

5 Transport, packaging and storage

WIKA operating instructions digital indicator DI10

5 Transport, packaging and storage

5.1 Transport

Check instrument for any damage that may have been caused by transport.
Obvious damage must be reported immediately.

5.2 Packaging

Do not remove packaging until just before mounting. Keep the packaging as it
will provide optimum protection during transport (e.g. change in installation
site, sending for repair).

5.3 Storage

Permissible conditions at the place of storage:

Storage temperature: -20 ... +80 °C
Humidity: 0 ... 80 % relative humidity (no condensation)

Avoid exposure to the following factors:

Direct sunlight or proximity to hot objects
Mechanical vibration, mechanical shock (putting it down hard)
Soot, vapour, dust and corrosive gases
Potentially explosive environments, flammable atmospheres

Store the instrument in its original packaging in a location that fulfils the
conditions listed above. If the original packaging is not available, pack and
store the instrument as described below:

1. Wrap the instrument in an antistatic plastic film.
2. Place the instrument, along with shock-absorbent material, in the

packaging.

3. If stored for a prolonged period of time (more than 30 days), place a

bag, containing a desiccant, inside the packaging.

WARNING!
Before storing the instrument (following operation), remove
any residual media. This is of particular importance if the
medium is hazardous to health, e.g. caustic, toxic,
carcinogenic, radioactive, etc.