WIKA TC10-L - Manual (Page 13)

WIKA operating instructions models TR10-L, TC10-L (Ex d)
3370964.05 04/2014 GB/D/F/E
13
GB
Possible sensor measuring ranges:
Model TR10-L: -200 ... +600 °C
Model TC10-L: -40 ... +1,200 °C
The following mounting and operating information has been compiled with care.
However, it is not possible to consider all potential usage cases.
4.2 Scope of delivery
Cross-check scope of delivery with delivery note.
5. Transport, packaging and storage
5.1 Transport
Check the instrument for any damage that may have been caused by transport.
Obvious damage must be reported immediately.
5.2 Packaging
Do not remove packaging until just before mounting. Keep the packaging as it will provide
optimum protection during transport (e.g. change in installation site, sending for repair).
5.3 Storage
Permissible conditions at the place of storage:
■ Storage temperature:
Instruments without built-in transmitter: -50 ... +85 °C
Instruments with built-in transmitter: see operating instructions of the corresponding
transmitter
■ Humidity: 35 ... 85 % relative humidity (no condensation)
Avoid exposure to the following factors:
■ Direct sunlight or proximity to hot objects
■ Mechanical vibration, mechanical shock (putting it down hard)
■ Soot, vapour, dust and corrosive gases
Store the instrument in its original packaging in a location that fulfils the conditions listed
above. If the original packaging is not available, pack and store the instrument as described
below:
1. Wrap the instrument in an antistatic plastic film.
2. Place the instrument along with shock-absorbent material in the packaging.
3. If stored for a prolonged period of time (more than 30 days), place a bag containing a
desiccant inside the packaging.
4. Design and function / 5. Transport, packaging and storage