Kramer Electronics TP-125EDID - Manual (Page 16)

TP-121/3/5EDID, PT-110EDID - Your TP-123EDID 13
To connect the TP-123EDID and the TP-124, as the example in Figure 4
illustrates, do the following:
1. On the TP-123EDID, connect the:
 XGA source (for example, a laptop’s graphics card) to the XGA IN
15-pin HD (F) connector
 Audio source (for example, the audio out of the PC) to the AUDIO IN
3.5mm mini jack
You can use a Kramer C-GMA/GMA cable (VGA 15-pin HD (M) + audio jack to
VGA 15-pin HD (M) + audio jack) to make both connections on one cable.
Cables are not supplied. The complete list of Kramer cables is on our Web site at
http://www.kramerelectronics.com.

RS-232 cable with a 9-pin D-sub connector to the laptop, and a 2-pin
terminal block connector to the TP-123EDID RS-232 port (as shown in
Figure 5 ).
2. On the TP-124, connect:
 The XGA OUT 15-pin HD (F) connector to a display
 The S/PDIF audio OUT RCA connector to a digital AV receiver (leave
the ANALOG audio OUT 3.5mm mini jack unconnected)
 An RS-232 cable with a 2-pin terminal block connector to the TP-124
RS-232 port, and a 9-pin D-sub connector to the RS-232 port on an
RS-232 controllable device (for example, a switcher)
3. Connect the Line OUT RJ-45 connector on the TP-123EDID to the LINE IN
RJ-45 connector on the TP-124, via CAT 5 cabling.
CAT 5 cable has a range of greater than 300ft (>100m). For details of how to wire a
CAT 5 LINE IN/LINE OUT RJ-45 connector, see
Section 8 .
4. Connect the 12V DC power adapter to the power socket and connect the
adapter to the mains electricity on both the TP-123EDID and the TP-124.
If you cannot connect the power to both the TP-123EDID and TP-124, connect the
power to any one unit.
5. On the TP-124:
 Adjust the video output signal level and/or cable compensation
equalization level, if required
Use a screwdriver to carefully rotate the trimmer, adjusting the appropriate level.