Kramer Electronics TP-125EDID - Manual (Page 11)

8 TP-121/3/5EDID, PT-110EDID - Your TP-121EDID
To connect the TP-121EDID with the TP-122N, as the example in Figure 2
illustrates, do the following:
1. On the TP-121EDID, connect the:
 XGA source (for example, a laptop’s graphics card) to the XGA IN
15-pin HD (F) connector
 Audio source (for example, the audio out of the PC) to the AUDIO IN
3.5mm mini jack
You can use a Kramer C-GMA/GMA cable (VGA 15-pin HD (M) + audio jack to
VGA 15-pin HD (M) + audio jack) to make both connections on one cable.
Cables are not supplied. The complete list of Kramer cables is on our Web site at
http://www.kramerelectronics.com.
2. On the TP-122N, connect the:
 XGA OUT 15-pin HD (F) connector to the XGA acceptor (for example,
a display)

AUDIO OUT S/PDIF RCA connector to the digital audio acceptor (for
example, an AV receiver)
 ANALOG 3.5mm mini jack to the analog audio acceptor (for example, a
stereo audio recorder)
3. Connect the LINE OUT RJ-45 connector on the TP-121EDID to the LINE IN
RJ-45 connector on the TP-122N, using CAT 5 cabling.
CAT 5 cable has a range of greater than 300ft (>100m). For details of how to wire a
CAT 5 LINE IN/LINE OUT RJ-45 connector, see
Section 8 .
4. Connect the 12V DC power adapter to the power socket and connect the adapter
to the mains electricity on both the TP-121EDID and the TP-122N.
If you cannot connect the power to both the TP-121EDID and TP-122N, connect the
power only to any one unit.
5. On the TP-122N:
 Adjust the video output signal level and/or cable compensation
equalization level, if required
Use a screwdriver to carefully rotate the trimmer, adjusting the appropriate level.
 If necessary, set the H SYNC and V SYNC switches, on the underside
By default, both switches are set down (for negative V SYNC and H SYNC
polarity).