Kramer Electronics VP-790 - Manual (Page 17)

12 VP-790 - Configuring the VP-790 via the OSD MENU Screens
6 Configuring the VP-790 via the OSD MENU
Screens
The VP-790 uses an on-screen display (OSD) menu for system configuration. The
menu appears as an overlay over any images that are output from the VP-790.
There are seven sub-menus (the PIP and Multiunit menus automatically replace
each other in the Single Unit mode and the Multi-unit mode, respectively) that are
used to configure the VP-790. You can activate and navigate these menus from the
front panel buttons or from the IR remote control.
Single Unit Mode Menu Items:
Multi-Unit Mode Menu Items:
Figure 4: MENU Items
To access and use the OSD menus, push the button for the desired input signal
(alternatively, you can select the desired input via the Input OSD menu), then press
the MENU front panel OSD button or the MENU key on the infrared remote control
transmitter to display the main MENU screen which shows the seven interactive
icons.

Press the  or  buttons to select the desired sub-menu, and then press
ENTER

Press the  or  buttons to select the menu item to be adjusted, and then
press ENTER

Press the  or  buttons to make the adjustment and then press ENTER

Press the  or  buttons to increase or decrease the (numerical) value as
needed