Kramer Electronics VS-81ETH - Manual (Page 17)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting and Controlling the VS-81ETH
14
5.6.1.2 Connecting via a Straight-Through Cable
If connecting the Ethernet port of the VS-81ETH to the LAN port on a
network hub or network router, use a straight-through cable with RJ-45
connectors, as Table 6 defines:
Table 6: Straight-through Cable RJ-45 PINOUT
Side 1 Side 2
PIN Wire Color PIN Wire Color
1 White-orange 1 White-orange
2 Orange 2 Orange
3 White-green 3 White-green
4 Blue 4 Blue
5 White-blue 5 White-blue
6 Green 6 Green
7 White-brown 7 White-brown
8 Brown 8 Brown
5.6.2 Installing and Running the XPort Configuration Software
To configure the Ethernet port, you have to install and run the XPort
configuration software.
It is important to consider the
following points before logging into and
configuring the Ethernet port:
The VS-81ETH IP address must be configured before a network
connection is available
Only one person at a time may be logged into the network port. This
eliminates the possibility of several people simultaneously attempting to
configure the Device Server
Network port logins can be disabled. The system manager will not be able
to access the unit. This port can also be password protected
5.6.2.1 Install XPort™ Installer
To install the XPort™ Installer, do the following:
1. Insert the product CD into your CD-ROM drive.
2. Run the XPort installer setup.
3. Respond to the installation wizard prompts.
4. Restart your system.