Kramer Electronics VS-808TP - Manual (Page 18)

14
VS-808TP - Operating the VS-808TP Locally via the Front Panel Buttons
7 Operating the VS-808TP Locally via the
Front Panel Buttons
The VS-808TP is operated using the front panels buttons as follows:
•
Press the left (
◄) or right (►) arrows to move backward or forward to select
the output of a switched pair
•
Press the up (
▲) or down (▼) arrows to move up or down through available
input channels
•
Press Enter to activate changes
You can set or change several outputs together and then press Enter to finalize
the operation. Prior to pressing Enter the display reflects the changes but the
changes are not implemented.
When audio switching is active (the Audio button LED is lit) only audio channels
are switched.
Note: This mode is not supported in the Data & Audio Bypass mode for the
TP-125/126.
Note: Performing a video switch overwrites a previously implemented audio
switch.
Any of the local or remote inputs can be switched to any or all of the local or
remote outputs for the TP-133/134 only. For the TP-125/126, local input and
output ports cannot be used.
The PC In input can be used to accept signals from a local source. Inputs 1 to 8
accept signals from remote transmitters and Outputs 1 to 8 can be used to send
signals to remote receivers. The PC Out output can be used to send signals to a
local acceptor (for example, an LCD monitor).
When the VS-808TP is powered on, the following is displayed briefly:
Loading .........