Kramer Electronics VP-31 - Manual (Page 13)

Figure 5: Typical VS-2000 System Setup
9.4.2 DIP Switches
The VP-61RS selects one of 6 VGA/Super-VGA/XGA standard signals. As said before there are two options
for operating the switcher, both are available without removing the switcher cover.
It can be operated by touching one of the front panel switches.
It can be operated by a remote PC via the RS-232 connectors on its rear panel.
The DIP switch (see Table 4) on the rear panel is used when the switcher is operated via the RS-232 connector
or when it is interconnected with other switchers. These switches allow proper configuration of the control
signals received/transmitted through the RS-232 control port. The VP-61RS allows master/slave
configurations so that the switchers may operate independently, or in conjunction with each other.