Mittler Bros Machine & Tool 2500 - Manual (Page 23)

- 23 -
MAINTANANCE
WARNING
Be sure the cylinder is completely retracted and that the hydraulic
pump is disconnected before servicing this machine.
· There are two bearing blocks that are greaseable. These
can be accessed from under the top by looking in from the
opening. The lower fitting is visible and the upper fitting is up
between the frame rails of the bender. A few pumps of high
quality grease every month is recommended for average
use. If you are using the bender on a more aggressive
schedule, shorten the intervals between greasing.
· Using the same grease that you use for the bearings brush a
small amount on the rack teeth when ever the bearings are
greased. If the rack teeth seem dirty or gritty clean them before
applying the grease.
Recommended Hydraulic Oil:
AW46 with Foam Suppressant
Digital Read Out Assembly Battery:
SR44 1.5 Vol
Lower Grease
Fitting
Upper Grease
Fitting
Grease on
Rack Teeth
BLACK Fill / Vent
Plug