Mittler Bros Machine & Tool 50220 - Manual

10” Wireless
RaceScale
Instructions
Racing Products
By
10” Pads
If there is interference with the operation of the scales (ex. much slower operation
than normal or no operation at all) it may be necessarry to change the frequency.
This can be done by following these steps.
1. Set all scale pads out individually (at least 12” apart).
2. Pivot the hand held antenna until the antenna is perpindicular to the floor (this
is essential for communication between the pads and hand held) and turn the
hand held on by pushing the “ON/OFF” button. DO NOT turn the scale pads
on at this time.
3. When the menu appears, select “RF Frequency” by pressing the “OK” button.
Give the unit a few seconds to scan the channels and you will see numbers
appear under “ACTIVITY”. Scroll the arrow down and select the frequency
with the lowest number (least amount of interference) by pressing “OK”.
(Typically 903-915 commumicate the fastest.)
4. Turn the hand held off by pushing the “ON/OFF” button for 2 seconds.
5. Turn the scale pads on by switching the battery switch on each scale pad to
“ON” and press the reset button on the front of the black box.(Green light will
start blinking indicating power is on.)
6. Turn the hand held back on by pushing the “ON/OFF” button.
7. When the menu appears, select “Weigh Vehicle” by pressing the “OK” button.
Give the hand held 2 minutes to start communication with the scale pads.
When the red lights on ALL scale pads are blinking and numbers appear on
the scaling screen the frequency has been changed and the scales are ready
to use. If you find that one scale does not blink red after 2 minutes, simply
turn that scale off and back on and press the reset button.
Frequency Change Instructions
For Further Technical Assistance Please Contact
Tanner Racing Products by MB
10 Cooperative Way Wright City, MO 63390
P.O. Box 110 Foristell, MO 63348
1-800-467-2464 Fax 1-636-745-2874
www.tannerracing.com
www.mittlerbros.com