beautypg.com

Mittler Bros Machine & Tool 2500-400 Bend Stop User Manual

Mittler Bros Machine & Tool Accessories for water

background image

Division of Mittler Corp.

P.O. Box 110 Foristell, Missouri 63348

10 Cooperative Way Wright City, MO 63390

(636) 745-7757

Fax: (636) 745-2874

\\Mbserver01\Engineering\Product\Product Documentation\2500 180 HYD Bender\Bend Stop Instructions\Bend Stop Hook Up Instructionsl VER2.doc Rev2 12-14-2006

2500-400 Bend Stop

For 2500 180° Hydraulic Bender

1. Check to see if your bender has the old style (simple angle iron) or new style mount as shown

below. If you have the old style bracket go to step #2. If you have the new style bracket go to step
# 3.

2. If you have the old style mount, remove the return spring carefully and then unbolt the bracket

from the rack.

3. Mount the new style bracket to the rack being sure to use the 1-1/4” long allen bolt, flat washer &

lock washer in the hole closest to the cylinder.

This is critical so the rack does not bind on the

cylinder.











4. Bolt the STOP WHEEL assembly to the new style bracket. Use the supplied shoulder bolt, spring

washer and Nylock nut installed as shown below. Install the DETENT BUTTON as shown, set the
tension and then jam the nut.










5. Bolt the Air Switch bracket to the bearing mounting block. Remove the installed bolts and use the

supplied 1-1/2” allen bolts to attach the bracket. Be sure the bolts are

TIGHT

.








New Style Bracket

1-1/4” Bolt with
washer & lock
washer installed.

Cylinder

Stop Wheel
Assembly

Shoulder Bolt

Spring Washer

Nylok Nut

Detent Plunger

Air Switch
Bracket

3/8” x 1-1/2” Long
Supplied Bolts