Mittler Bros Machine & Tool 50220-OLD - Manual

10" WIRELESS
RaceScale
#50220
Instructions
FOR FURTHER TECHNICAL ASSISTANCE CONTACT:
TANNER RACING PRODUCTS by MB
10 COOPERATIVE WAY
WRIGHT CITY, MO. 63390
800-467-2464 / 636-745-7757
TannerRacing.com
Frequency Change Instructions
If there is interference with the operation of the scales (ex. much slower operation
than normal or no operation at all) it may be necessarry to change the frequency.
This can be done by following these steps.
1. Set all scale pads out individually (at least 12" apart).
2. Pivot the hand held antenna until the antenna is perpindicular to the floor (this
is essential for communication between the pads and hand held) and turn the hand
held on by pushing the "ON/OFF" button. DO NOT turn the scale pads on at this
time.
3. When the menu appears, select "RF Frequency" by pressing the "OK" button.
Give the unit a few seconds to scan the channels and you will see numbers appear
under "ACTIVITY". Scroll the arrow down and select the frequency with the low-
est number (least amount of interference) by pressing "OK". (Typically 903-915
commumicate the fastest.)
4. Turn the hand held off by pushing the "ON/OFF" button for 2 seconds.
5. Turn the scale pads on by switching the battery switch on each scale pad to
"ON" and press the reset button on the front of the black box.(Green light will start
blinking indicating power is on.)
6. Turn the hand held back on by pushing the "ON/OFF" button.
7. When the menu appears, select "Weigh Vehicle" by pressing the "OK" button.
Give the hand held 2 minutes to start communication with the scale pads. When the
red lights on ALL scale pads are blinking and numbers appear on the scaling screen
the frequency has been changed and the scales are ready to use. If you find that one
scale does not blink red after 2 minutes, simply turn that scale off and back on and
press the reset button.
Hand Held
Battery Charger
Communications
Cable
Hand Held
Scale Display