Rugged Ridge XHD Low/High Mount Snorkel System, 07-11 Jeep Wrangler (JK) - Manual (Page 25)

Page 1 of 3 REV.1 06/25/2012
High Intake Installation Instructions: (2007 - UP) Wrangler 2DR & 4DR Unlimited
P/N: 17756.07 - XHD Modular High Mount (Ram intake)
Contents:
(1) High intake
(1) Ram intake
(1) 3” Clamp
(1) Foam gasket (Intake)
(1) Mounting bracket
(4) M6 X 55 Caps head bolt
(4) M6 Flat washer -
(2) M6 x 10 Hex head bolt
(2) M6 Flat washer
PLEASE NOTE: Modular high mount XHD intake has been designed for use with Rugged Ridge
accessories. If vehicle is equipped with another manufactures accessories modification
to accessories may be required. It is recommended that no modifications are made
to the snorkel or snorkel intake system. Modifications to intake may result in reduction
of vehicle performance.
Low intake Removal:
2
- Remove lower (2) M6 side
mount caps head bolts.
Remove logo plate but
do not discard. It will be
reused. Do Not discard
hardware. It will be reused
if low mount intake is to be
installed at a later date.
3
- Remove low mount intake.
Make sure “U” gasket is
retained for future use.
1
- Remove top (4) M6 caps
head bolts and washers.
Do Not discard hardware.
Hardware will be required
if low mount intake is to
be reinstalled at a later
date.