Rugged Ridge XHD Low/High Mount Snorkel System, 07-11 Jeep Wrangler (JK) - Manual (Page 23)

Page 23 of 23 REV.1 06/25/2012
Omix-Ada Inc.
460 Horizon Dr. Suite 400
Suwanee, Georgia 30024
P/N: 17756.06 - Fender Template (1:1 scale)
CUT OUT LOCA
TION
GUIDE CUT
OUT
GUIDE CUT
OUT
FOLD
ALONG DOTTED LINE
FOLD
ALONG DOTTED LINE
Cut out template using scissors or X-ATCO blade. The template
is a (1:1) scale guide for cutting top of passenger side (LH) fender.
NOTICE: Make sure guide cut outs align correctly with the top
of fender. If guide cut outs DO NOT MATCH top of fender
please contact Rugged Ridge for correct template. Template
ratio can change size during the printing process. Every effort
is made to insure correct sizing of template for installation but
we do request that it is double checked prior to marking and
cutting of vehicle fender. Failure to follow instructions may
result in a poor fitting component or damage to fender.
(770) - 614-6101 (Attn: Tech Department)
Snorkel system has been designed to reduce possible
hydro locking caused by water entering intake system. The
system is designed to provide dry, clean air to the engine and
should not be used to exceed manufactures recommended
fording depth. Proper off road driving technics should be used
when fording any type of legal water crossing. It is the owners
responsibility to judge conditions prior to placing vehicle in
a situation where water intake is possible. The system should
be used as a safeguard and not a full 100% sealed intake
sytem. Rugged Ridge / Omix-Ada Inc. is not responsible for
damages caused by improper installation an or use of snorkel
system. System should be cleaned and flushed annually. Drain
should be inspected and water expelled on a regular basis.
Manufactures warranty covers only products supplied by
Rugged Ridge / Omix - Ada Inc.