beautypg.com

Rugged Ridge XHD Low/High Mount Snorkel System, 07-11 Jeep Wrangler (JK) User Manual

Page 18

background image

Page 18 of 23 REV.1 06/25/2012

Snorkel Installation Instructions: 2007-2011 Wrangler 2DR & 4DR Unlimited

P/N: 17756.06 - Low Mount XHD Modular Snorkel System

101

- Secure all (4) M6 cowl

mounting screws. Make

sure M6 black washers

are placed under M6

screws before tightening.

100

- Slide nut plate under

snorkel body as shown.

Working from engine

compartment align

mounting holes. Start

one M6 Phillips head

screw to hold in place.

102

- Reinstall wiper arms

removed in step (4).

103

- Slide 3/8” drain hose

and 3/8” clamp to

bottom of snorkel

body.

104

- Hose should be cut

into two lengths. Top

section should be

about 8” long. The

lower section will be

4” and trimmed as

needed. Connect 3/8”

clamps to valve and

tighten all (3) clamps.

105

- Drain should be

checked before fender

is installed. Open and

close valve.

Drain should be

lowered and checked

to remove any excess

water on a regular basis.