Rugged Ridge XHD Low/High Mount Snorkel System, 07-11 Jeep Wrangler (JK) - Manual (Page 11)

Page 11 of 23 REV.1 06/25/2012
Snorkel Installation Instructions: 2007-2011 Wrangler 2DR & 4DR Unlimited
P/N: 17756.06 - Low Mount XHD Modular Snorkel System
59
- Apply quality sealant to
inside of 90 degree elbow.
sealant should be applied
evenly around the inside
of opening. If tube has
been trimmed apply to
uncut end.
58
- Reinstall clamps to new
lower air box. Slide open
end of clamp through
plastic tabs and pull down
and to the left and right.
This will lock clamp into
position.
61
- Place 2nd 3” clamp over
elbow and slide onto
air tube.
62
- Slide first 3” clamp over
elbow. Slide elbow back
to notch in air tube
(see arrow). Clean away
extra sealant . Do Not
tighten clamp at this
time.
60
- Apply small amount
of sealant around air
tube near shock tower
notch. Apply evenly
around tube.
63
- Apply sealant around
inside top of elbow. Be
sure sealant is spread
evenly around inside of
elbow. Spread sealant
should be about 1”
wide.