Goulds Pumps ANSI FAMILY IOM (ATEX Compliant) - IOM - Manual (Page 57)

DISASSEMBLY & REASSEMBLY
REQUIRED TOOLS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 55
DISASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 55
INSPECTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 68
REASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 74
REQUIRED TOOLS
DISASSEMBLY
s
! WARNING
Pump components can be heavy. Proper
methods of lifting must be employed to avoid
physical injury and/or equipment damage.
Steel toed shoes must be worn at all times.
s
! WARNING
The pump may handle hazardous and/or toxic
fluids. Proper personal protective equipment
should be worn. Precautions must be taken to
prevent physical injury. Pumpage must be
handled and disposed of in conformance with
applicable environmental regulations.
NOTE: Before disassembling the pump for
overhaul, ensure all replacement parts are
available.
s
! WARNING
Lock out power supply to driver motor to
prevent accidental startup and physical injury.
1. Shut off all valves controlling flow to and from
pump.
s
! WARNING
Operator must be aware of pumpage and safety
precautions to prevent physical injury.
2. Drain liquid from piping, flush pump if necessary.
If pump is a Model NM3196 or a 3198 there
may be a risk of static electric discharge
from plastic parts that are not properly
grounded. If pumped fluid is
non-conductive, pump should be drained
and flushed with a conductive fluid under
conditions that will not allow for a spark to
be released to the atmosphere.
ANSIFAM IOM - 5/08
55
6
•
Wrenches
•
Screwdriver
•
Lifting Sling
•
Rubber Mallet
•
Induction Bearing Heater
•
Bearing Puller
•
Brass Drift Punch
•
Snap-Ring Pliers
•
Torque Wrench with Sockets
•
Allen Wrenches
•
Dial Indicator
•
Micrometer
•
Cleaning Agents
•
Feeler Gauges
•
Hydraulic Press
•
Leveling Blocks