Acer N10 - Manual (Page 21)

1 G e t t i n g s t a r t e d
Preparing to use your Acer n10
9
Plug the USB sync cable into the mini USB port on the bottom of your handheld and
plug the other end into an available USB port on your computer
.
Charging your Acer n10
For initial use, you need to charge your handheld for three hours. After that, you can
charge it for a few minutes each day to recharge the battery to full capacity. Normally,
you can use your handheld for 12 straight hours of operation (backlight inactive)
before you need to recharge the battery.
To charge your Acer n10
Connect the AC adapter connector to the handheld, then plug the other end of the
AC adapter into any AC outlet.
LED status during charging:
• Charging - LED indicator flashes green
• Charging complete - LED indicator steady green
If the battery level becomes low in the course of normal use, a status icon appears on
the handheld screen indicating low or very low battery status. Perform an ActiveSync
operation to back up your data; then recharge the battery.
If your handheld shuts down (i.e., battery is competely drained out) you have about
72 hours (3 days) to recharge the battery before you lose all data on your handheld’s
internal memory.
Setting up your Acer n10
After you have initially charged your handheld for three hours, you can now set it up.
Refer to the instructions below.