Myron L 760-A Aquaswitch - Manual (Page 7)

2.3 ELECTRICAL INSTALLATION
The Aquaswitch and 760-A Aquaswitch require the user to follow
separate electrical installation procedures. In addition, based on
the user’s solenoid voltage specifications, the user will be required
to connect optional Solenoid Power.
NOTE:
All cable watertight restraints are user supplied
2.3.1 AQUASWITCH MAIN AC POWER NOTE:
The following procedures are to be used to install the Aquaswitch
115 VAC main power source. For the procedures to install the
optional 220 VAC main power source, the user must first complete
the installation procedures in Section 2.3.3. Failure to do so could
result in damage to equipment, and/or property.
STEP 1 Verify that the facility’s 115 VAC power source is turned
OFF or disconnected.
STEP 2 Following STEPS 2 and 3 in Section 2.2.2, remove the
front panel.
STEP 3 Place the AC power cord and watertight cable restraint
into the enclosure’s appropriate access hole.
STEP 4 Neatly connect cable wires to the 760-A Control board
TB1 terminal block connectors as shown in Fig. 2-5.
5