Hydraulic filter maintenance – Hawk Industries Hawkjaw Jr. Manual 65K-2GJR Serial Numbers 21 to 32 User Manual

Page 35

Hydraulic Filter Maintenance

Change Every 2 Months

Initial Steps

1. Depress the Red button (RB)

located under the See-through
rubber weather cap (SC).

2. Operate the HawkJaw.
3. If the Red button pops up,

proceed with Step 4.

4. Make sure the HawkJaw is off the

drill pipe connection and in the rest
position on the derrick.

5. Shut down the Hydraulic power

unit.

6. Press, push, and pull all control

buttons repeatedly to bleed
hydraulic pressure.

7. Press the E-Stop (E) button on the

right control handle.

8. Disconnect the Air power supply.
9. Assume that there is still

pressure in the Pressure Line.
Proceed with caution.

Hydraulic Filter

1. Remove the Canister (C).
2. Remove the Filter Element (FE).
3. Insert the new Filter Element.
4. Replace the Filter Canister (C).

Part Numbers

WARNING

Running the HawkJaw
without a Hawk approved
pressure-side filter (Part #
061-H25) voids the
warranty and severely
shortens component life.

NOTE

If the Canister (C)
leaks, change the
"O" ring and back-
up (S).

Maintenance & Repair

Maintenance

& Repair

Part Name

Part #

Filter

061-H25

Filter Element (FE)

061-H25A

Filter Cannister/Body (C) 061-H25B

Weather Cap (RB)

061-H25C

Filter Seal Kit (S)

061-H25SK