Wrench maintenance – Hawk Industries Hawkjaw Jr. Manual 65K-2GJR Serial Numbers 21 to 32 User Manual
Page 31

1. Make sure the HawkJaw is off the
drill pipe connection and in the rest
position on the derrick.
2. Shut down the Hydraulic power
unit.
3. Press, push, and pull all control
buttons repeatedly to bleed
hydraulic pressure.
4. Disconnect the Air power supply.
5. Press, push, and pull all control
buttons repeatedly to bleed air
pressure.
6. Assume that there is still a load on
every actuator. Proceed with
caution.
Wrench Maintenance
Grease Once per Trip
Initial Steps
D1
D2
D4
D3
D6
D5
Die Pivot Blocks
1. Pump grease fittings D1-D6.
NOTE
Consistent lubrication of the wrenches
increases performance and component
life.
Maintenance & Repair
31
Maintenance
& Repair